set to no the start of network interfaces.start the system with your official SME Server CDROM.I presume that your SME Server is on a RAID1 of two disks (sda, sdb), otherwise you will have to adapt this HOWTO. my sme is with Raid1 so I have two drives, you will need to adapt my example to your the number of disks.įix the GRUB with the official SME Server CDROM To reach the boot menu of the bios, will depend on your hardware. Grub must be installed on all other drives to give the capacity to operate the system. To /dev/sdb you issue the following commands, using one of the following disk labels (sdc, sdd, sde. Running "embed /grub/e2fs_stage1_5 d (hd0)". noĬhecking if "/grub/e2fs_stage1_5" exists. In a terminal at the command prompt issue the following commandsįilesystem type is ext2fs, partition type 0xfdĬhecking if "/boot/grub/stage1" exists. I presume that your SME Server is using a RAID1 of two disks, otherwise you have to adapt this HOWTO to your setup. Normally if grub can not start and your system is not damagaed, you will have a basic system prompt. There may be an occasion when an issue with grub will cause your server to not boot, there is no need to reinstall the system, you just need to repair the installation of grub.įix the GRUB from the startup command line 4.1 Installation of grub on other disks.3 Fix the GRUB with the official SME Server CDROM.2 Fix the GRUB from the startup command line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |